A water softener recharges its resin in two steps. During regeneration, the injector uses the flow of water through a small venturi to pull salt solution from the brine tank into the resin tank. When the injector or its screen is clogged with sediment or grit, the unit can keep running its cycle on time while the brine draw is weak or missing. The resin then does not fully recharge, and hardness can creep back through the house without any obvious alarm.

Signs the injector needs a look

Watch for the salt level in the brine tank barely dropping between refills, brine tank water that stays almost level after a regeneration, hardness returning sooner than it used to, or no change in sound or flow during the brine draw step. The exact sound and sequence differ by model, so check your manual for what a normal draw looks like on your unit before you decide something is wrong.

Before you open anything

Read the service section of your manual first. If your system has a bypass valve, set it per the manual so the house keeps water while you work, and understand that bypass sends untreated water to the taps. Shut the water supply only if the manual calls for it, and relieve the pressure before you loosen any fitting. If the manual says to unplug the control head before handling parts, do that first.

Clean the injector and screen

Remove the injector cap or plug as the manual describes. On some models the nozzle and throat come out as one cartridge, and on others they are separate pieces. Look at the screen and the small nozzle opening for grit, sediment, or resin fragments. Rinse the parts in clean water and clear the openings with a soft brush or a pipe cleaner. Do not use metal tools that can scratch the nozzle opening, because a scratched nozzle changes the draw in a way that is hard to diagnose later.

Inspect the O-rings for flattening, nicks, or cracks. If they look worn, replace them with the kit listed for your model, and lubricate only with the type the manual names. Reassemble by hand until snug. Plastic threads crack when overtightened, so stop as soon as the parts seat evenly.

Restore water and power, then run a manual regeneration while you watch. You should see the brine tank level fall and hear or see the draw step at the point your manual describes. If the draw is now normal, the problem was most likely the screen or a worn seal.

When to stop and call

Stop and call the service provider if the injector body is cracked, a piece is missing, the screen is torn, or the draw still fails after a clean and reassembly. Forcing a damaged injector can cause leaks or push brine where it should not go. Before you open the unit at all, check the warranty terms, because some warranties specify who may perform service work.

What to record and what to ask

Write down what you cleaned, which O-rings you replaced, and the part numbers you used, then add that to the unit's service notes. When you talk to a provider, ask whether the injector is sold as a separate part or as a cartridge, whether the screen can be replaced alone, and how often they expect the injector to be checked for your water and use. Those answers tell you whether this is a quick owner task or a job to schedule with a professional.

If you are still deciding which kind of unit suits your water and household, the find-your-system quiz on the Compare Water Treatment home page is a useful starting point before you compare providers.