A softener cleans itself on a schedule. The control head runs a cycle that flushes the resin bed with brine and then rinses it, and the job depends on that cycle starting at the right hour. When the clock is wrong, or the timer loses its settings, the cycle can land in the middle of a shower or stop firing altogether. Either way you get trouble you can see: water that is harder than it should be, or a unit working at the wrong time.
What goes wrong
Most of these failures are simple. A power interruption can reset the clock on some timers, leaving the display blinking or showing a time that is hours off. A regeneration set for 2 a.m. can end up running in the afternoon if the AM or PM setting was wrong from the start. Some units keep the factory default regeneration time because nobody changed it after installation, so the cycle runs whenever the default says, which may not suit your household. If the unit regenerates on demand, measured by a meter instead of a clock, the failure looks different. The meter that triggers the cycle can stop counting, so the cycle never starts and the resin stays exhausted.
How to tell from the house
Watch the first things you notice rather than waiting for a complete failure. Water that runs cold, sputters, or drops in pressure for a few minutes in the early morning or evening may be a cycle overlapping your use. A steady draining sound from the unit, or from the floor drain, when no one is running water can mean a cycle is in progress at an odd hour. On the other side, if soap scum returns, the shower feels squeaky again, or glass that was clean a few weeks ago starts spotting, the resin may not be regenerating at all. Salt that drops faster than usual with no change in your habits is worth noting too, since it can mean cycles are running more often than planned.
Check the settings, not just the display
Stand at the unit with the manual or the install paperwork and confirm four things: the current time of day, the regeneration time, whether the unit runs on a clock or on demand, and the length of the regeneration cycle. Write them down with the day you checked them so you can compare later. If the display shows the wrong time, reset the clock to local time and look again the next morning. If it resets after a power dip, the timer is not holding its memory. That is a problem to raise with the provider, not something to fix with repeated resets.
Pick a time that fits your house
A regeneration set for the middle of the night is the usual choice because it avoids the hours when people shower, run the dishwasher, or do laundry. If your household runs an unusual pattern, such as someone up overnight on shift work or guests running water late, ask the provider where the cycle is set and whether it can move. Do not guess at a new hour and leave it there. Ask the installer what hour they chose at install and why, then decide the change together.
What to ask the provider
Ask a few direct questions before you need the answers. Does the timer keep its settings through a power outage, and does it have a backup? Who set the regeneration time at installation, and is it written down? Does a service visit reset the clock, and will the technician show you how to check it? If the unit runs on a meter, what happens to the cycle count if the meter stalls? A provider who answers these plainly is easier to hold to a schedule than one who waves the question off. If you are comparing providers on this point, our methodology page explains how we weigh service questions like these.
When to call
If the clock resets repeatedly, the cycle keeps landing at the wrong hour after you have corrected it, or the water turns hard between cycles, stop adjusting the settings yourself and call the provider. Those symptoms point to the control or the valve, and the repair belongs to whoever services the unit. Until then, keep the notes you took and tell them what you saw and when.