A water treatment system holds water in tanks, housings, and lines, and water expands when it freezes. A unit that freezes can crack a tank head, a valve body, or a connection, and the damage often shows up only after the weather warms and the water starts moving again. If your system sits in a garage, an unheated crawlspace, a utility room against an exterior wall, or a basement corner that drops cold, freezing protection belongs on your checklist.
Walk the room before the cold does
Stand where the unit sits and note three things: whether the room stays above freezing on its coldest night, whether any supply or drain line runs along an exterior wall or near an outside vent, and whether a door, window, or gap lets in outside air. Write down what you find. If you cannot tell how cold the room gets, a cheap thermometer left there through a few cold nights will tell you more than a guess.
Ask the provider what they expect you to do
Not every system is built for an unheated space, and the manufacturer's manual is the first place to check. Ask your provider three things in writing: whether the unit is rated for the room where it sits, what freeze protection they recommend for that location, and whether any heat cable or insulation they suggest would affect the warranty. If they recommend a heat cable, ask who installs it and who checks the outlet it plugs into. Electrical work should go to a licensed electrician, and any plumbing changes should follow the manual.
Plan for the empty house
The riskiest time is when no one is home. If the house will sit with the heat turned down, decide before the cold arrives whether the water supply to the system gets shut off and drained, or whether the heat stays on at a level that protects the room. Name the person who makes that call and the person who checks the room. A written note by the shutoff valve saying what was done and when saves a lot of guessing when you return.
After a cold spell, check before you run water
Before you restart normal use after a hard freeze, look at the tank heads, valve connections, and fittings for drips, bulges, or cracks, and check the drain line for ice. If anything looks wrong, keep the supply shut off and call the provider. Add the freeze event to your service record so the next visit starts with the full history.