A sediment filter does its job by catching particles, and as it fills, water has to push harder to get through it. The change shows up as a gap between the pressure on the water coming in and the pressure on the water going out. That gap is called the pressure drop, and it is often a better guide to when the element needs attention than a fixed schedule written on the box.
What you need before you read anything
Check whether your filter housing has a gauge on the inlet side, the outlet side, or both. If there is only one gauge, ask the installer whether a second one can be added, or whether a handheld gauge can be attached at a test port. Without two readings taken at the same time, you cannot calculate the drop.
Ask the provider or the manufacturer for two numbers in writing: the normal reading for a clean element on your system, and the drop at which they want the element replaced. Some manuals give a threshold. Others only describe a general range. If you get no answer, do not guess. Write down what they told you and keep it with your maintenance log.
How to take the reading so it means something
Take both readings on the same day, at the same time of day, with the same fixtures running. A kitchen tap, a laundry cycle, or an irrigation zone can change the numbers, so note what was running. Read the gauges once with no demand on the system and once with a steady flow if your setup allows that. Write the date and the two numbers in your log every time.
Keep the first readings you take after a fresh element is installed. Those become your baseline. A reading that looks high means nothing on its own, but a reading that has climbed steadily from the baseline tells you the element is loading up.
What to do when the drop grows
When the gap reaches the replacement threshold in your paperwork, plan the change rather than waiting for the water to slow down at the tap. A slow tap usually means the element has been loaded for some time. Before you open the housing, shut off the supply to the filter and relieve the pressure as the manual describes. Do not add a second sediment filter in front of the first without asking the provider whether your system is built for it, since a stacked setup can change the flow and the drop in ways the original design did not plan for.
If the drop climbs quickly after a change, stop and check for something other than a normal loading pattern. A housing that was closed unevenly, an O-ring that was not seated, or a supply problem upstream can all raise the reading. Record what you found so the next person who reads the log can see the pattern.
Keep the clock in the log
The drop readings belong with your other service records: the date of each change, the element part number, the baseline reading, and the replacement threshold you were given. Over time the log shows how fast your water loads the filter, which is far more useful than any general estimate. When a question comes up about cost or who does the work, the log gives you the facts to answer it.