Before anyone cuts pipe, three choices should already be made: where the main shutoff is, where the unit will sit, and whether a bypass is installed. If any of those is unclear, stop and settle it first. Cutting a line you have not planned to reconnect is the most common way a simple install turns into a second visit.

The sequence

  1. Confirm the main shutoff closes fully. Open a faucet on the lowest level of the house and check that the flow stops. A valve that does not close all the way needs repair or replacement before the install, not during it.

  2. Relieve the pressure and drain the section you will cut. Keep a bucket and towels nearby, and expect some water to stay in the line.

  3. Dry-fit the unit, bypass, and pipe sections before cutting anything. Mark each cut point, and check that the flow arrows on the housings point the same way as the water.

  4. Cut, deburr, and fit the sections. Keep the bypass valves in the closed position at this stage so no water runs through the unit yet.

  5. Restore the main slowly. Check every joint while the water is on, and look at them again after a few minutes, since some leaks show up only once the line is pressurized.

  6. Open the bypass only after the joints are dry, then bring the unit into service. Setting the valves for normal use and purging air come after the leak check, and they are a separate step.

Joint types and who does them

Soldered copper joints need a clean, dry pipe and a safe work area. Press fittings and compression fittings need the correct tool and a square cut. If you are not comfortable with the joint type your home uses, ask the installer which joints they plan to make and why. A straightforward answer is a good sign. A vague one is a reason to ask for a walk-through before the day starts.

Check before you start

Ask whether a plumbing permit or inspection applies to the connections in your area. Local rules differ, and some jurisdictions require a licensed plumber for certain tie-ins. Confirm this before the crew arrives so the work does not stop halfway through the day.