A water softener or filter adds a restriction that most homes never had before, but the bigger issue for some houses is what happens when the water heats up. If your home has a check valve, a backflow preventer, or a pressure-reducing valve on the main supply line, cold water has nowhere to go when the heater warms it and expands. The pressure climbs. An expansion tank gives that extra water a place to sit.
Check what is already on the supply line
Look where the main line enters the house, usually near the water meter, the main shutoff, or the wall where the line comes in from the street. Note any device with a spring, a flat cover, or a label that says check valve, backflow, or pressure reducing. Your provider and your plumber can both identify these, but you can confirm the basics yourself. If the supply has none of these devices, a closed system is less likely, and the tank question may not apply to your house.
Look for the signs of pressure buildup
Pressure buildup usually shows up in a few places. The water heater's temperature and pressure relief valve may drip or spit water on its own, especially after the heater has run. Faucets may sound louder when they shut off. Fill valves and fixtures may start to weep at their joints. None of these prove the cause, but they tell you to check the pressure.
Measure the static pressure
A basic pressure gauge threaded onto an outdoor hose bib, read with no water running inside, gives you the static reading. Take the reading in the morning before anyone runs water, and again after the heater has run. Write both numbers down. A rise after heating points toward expansion. Pressure that is already high before the heater starts is a separate problem, and a pressure-reducing valve is the first part to inspect.
Decide who sizes and mounts the tank
The tank itself is a single part, but the right size depends on your water heater volume, your system pressure, and how your supply valves are arranged. Ask the provider whether the tank is in the quote and who chooses its size. If they propose one, ask what it was matched to. Ask whether it goes on the cold line feeding the heater, which is the usual location, and whether it gets its own shutoff and drain.
What you can do yourself and what to hire out
Reading the gauge, finding the check valve or pressure-reducing valve, and writing down the readings are reasonable tasks for a homeowner. Cutting into the cold line, adding a tee, soldering or fitting connections, and tying the tank into the heater are plumbing work. If you lack the tools or the experience, that job belongs with a licensed plumber. Find out before you sign whether the provider's installer will do it or whether you must hire someone separately. A tank that the install crew skips can leave you with a dripping relief valve and no one clearly responsible for it.
Questions to put to the provider
Ask whether your home has a closed system and how they checked. Ask whether the tank is in the quote and what size it is. Ask who makes the connection to the heater and who answers if the relief valve drips in the first month. Ask where the tank sits and whether you can reach it for future checks. Compare the answers across providers. Our methodology page explains how we line up providers on the same questions. Keep the written answers with your install paperwork.