A water treatment system rarely fails with a flood. More often it starts with a small wet spot under the cabinet that looks like nothing: a bead of moisture on a fitting, a faint ring on the cabinet floor, or a white crust that you scrape off every few weeks. That slow weep is the failure worth catching early, because ignoring it costs you cabinet floors and soft subfloor long before it stops the system.

Where slow leaks usually start

Start with the joints. Compression fittings on the supply and outlet lines, the nut where the bypass valve meets the valve head, the inlet and outlet connections on the tank or filter housing, and the drain connection all see repeated pressure cycling. A fitting that was snug at install can loosen slightly as pipes settle or the system cycles, and a valve stem seal can weep well before it drips.

On a softener, look hard at the brine line connections. Salt residue that dries into a pale crust around a fitting means water has been reaching that spot and evaporating, even if you never saw a drop fall.

How to check without guessing

Dry the area completely with a towel. Place a dry paper towel or a strip of tape under each joint, then check it after a few hours and again the next morning. Use a flashlight along the lines and look for beads, streaks, or a darkened ring on the cabinet floor. Press on the cabinet floor near the edges and the bottom of the cabinet wall for softness or swelling. A musty smell inside the cabinet is a leak signal, not just a cleaning problem.

What you can fix yourself and when to stop

Before touching anything, shut off the water supply to the system using the shutoff that serves your setup. Then, by hand or with a small wrench, give a wet compression nut a gentle snug, a fraction of a turn at a time. Do not crank on plastic fittings or valve bodies. Over-tightening is one of the most common ways to turn a small weep into a cracked part.

Stop and call the provider or a plumber when the drip returns after a gentle snug, when the water comes from a valve body or cracked housing rather than a nut, when the floor is already soft, or when you cannot isolate the system without shutting off water to the whole house. Write down where the leak is and when you noticed it, and take a photo if you can. That description saves time for whoever comes out.

Make the look a routine

Add a short look under the cabinet to the monthly routine you already use for filters or salt. The joint that was dry last time is the one to watch. A new residue line, a single drop on a towel, or a cabinet floor that feels different underfoot is far cheaper to fix now than after the wood has to be replaced.