A water softener that is plumbed in and running is not finished until its brine tank has been filled correctly. The brine tank holds the salt and the water that makes the brine. If the first fill goes wrong, the unit can look fine for days and then start to under-regenerate or leave salt sitting in a pile.

Check the fill before any salt goes in

With the lid off, find the fill line or float that the manual describes, and confirm the unit is set to the water level it expects. Make sure the brine well or safety float moves freely and is not pinned by packaging, a loose cap, or grit.

Add the salt the way the manual says

Use the salt type the manufacturer lists for water softeners, and fill to the level in the manual rather than to the top of the tank. Some salts form a crust or bridge over the water, so ask the installer how and when to check for that, and write the check into your service log.

Run the first brine draw and watch the water

When the manufacturer's startup steps call for a manual regeneration, start it and let the cycle finish without interrupting it. Watch the brine tank water level during the draw. It should drop, then refill to the fill line. If it keeps running or never refills, stop and call the installer rather than adding more water or salt.

What to record

Write down the salt level on the day you fill, the salt type, and the day the first regeneration ran. Keep the note with the startup log so the next visit begins from known numbers. At the first refill, check that the brine level sits at the fill mark between cycles and that no salt bridge has formed.