Most sizing advice starts with the people in the house. Some homes carry extra loads that never appear in a head count, such as irrigation, a pool you top off, a hot tub you refill, a large garden, or a line you draw from for animal water. Each one can change the flow and volume a system needs, and each one raises the question of which taps the system should serve.
List the outdoor and occasional loads
Write down each outdoor or occasional use with its rough timing: lawn watering in the warm months, a pool you top off, a hot tub you refill, or animal water drawn from the house line. Note whether any of these run at the same time as indoor peaks, such as the morning rush for showers. The overlap matters more than the total, because flow is what a system has to deliver in the busiest hour.
Decide which lines should be treated
Many homeowners do not want to treat irrigation or pool water, either because the volume is large or because the discharge from some systems is not something they want on the lawn. Ask each provider which lines they would connect to the treated supply and which would stay on the untreated line. Ask how a split would be labeled, and whether the outdoor line would get any treatment at all.
Ask how the provider sizes for peaks
Ask the provider how they account for peak flow, not just daily volume. Ask what flow rate they assumed for your busiest hour, and whether the outdoor loads were included in that figure. If the answer is only a daily total, ask for the arithmetic in writing. You can check the logic against our methodology page, which explains how systems are matched to household needs.
Plan for the load you may add later
A system sized for today's loads may struggle after a pool or a larger garden goes in. Ask whether the design leaves headroom, and what an upgrade would involve, whether that means pipe changes, a second unit, or a larger tank. Put that answer in the quote before you sign, so a future project is priced from the start rather than discovered later.